联系我们

保定市鑫鑫环保建材模具厂

电话:0312-8103011

手机:13403121185

联系人:吕经理

地址:保定东郊工业园区

新闻动态
路缘石模具的保养护理
要对路缘石模具进行护理,就要对几个重要零部件进行重点跟踪检测:顶出、导向部件的作用是确保水渠盖板模具开合运动及塑件顶出,若其中任何部位因损伤而卡住,将导致停产,故应经常保持模具顶针、导柱的润滑,并定期检查顶针、导柱等是否发生变形及表面损伤,一经发现,要及时更换。
To care for the road edge stone mold, we should focus on several important parts and parts. The function of the top out and guiding parts is to ensure the opening and closing of the die and the top out of the plastic parts. If any part is stuck because of the damage, it will cause the stop of production, so it should always keep the lubrication of the mold top needle and the guide column. It is necessary to detect the deformation and surface damage of thimble, guide pin and so on.

随着生产时间持续,冷却道易沉积水垢、锈蚀、淤泥及水藻等,使冷却流道截面变小,冷却通道变窄,大大降低冷却液与铁路公路盖板模具之间的热交换率,增加企业生产成本,因此对流道的清理应引起重视;对于热流道模具而言,加热及控制系统的保养有利于防止生产故障的发生,故而尤为重要。
With the continuous production time, the cooling channel easily deposited scale, rust, silt and algae, which made the cooling channel cross section smaller and the cooling channel narrowed, greatly reducing the heat exchange rate between the cooling solution and the railway highway cover die, and increasing the production cost of the enterprise. Therefore, the clear principle of the flow passage should be paid attention to. In terms of heating and control system maintenance, it is very important to prevent production failures.

在路缘石模具完成一个生产周期之后,要对模具工作表面、运动、导向部件涂覆专业的防锈油,尤应重视对带有齿轮、齿条模具轴承部位和弹簧模具的弹力强度的保护,以确保其始终处于最佳工作状态。
After a production cycle is completed, a professional anti rust oil is applied to the working surface, motion, and guide parts of the mold. The protection of the elastic strength of the gear, the bearing parts of the rack and the spring die should be emphasized so as to ensure that it is always in the best working condition.

联系方式

  1. 名称:保定市鑫鑫环保建材模具厂
  2. 电话:0312-8103011
  3. 手机:13403121185
  4. 联系人:吕经理
  5. 地址:保定东郊工业园区

版权  保定市鑫鑫建材模具厂 网址:www.suolijc.com  推荐:流水槽模具,塑料护坡模具,路缘石模具,便道砖模具